Job DescriptionOptimization:Monitor productivity and improve and stabilize manufacturing KPIs (Technical Availability, Reject Rate, Scrap, Downtime, CPKs, Cycle time). Support activities to address safety, quality, and productivity for the assigned manufacturing line using tools such as:5-whyShainin8D6 SigmaDOE6SSCIPPDCAStart process-FMEA, frame and release, update. Execute FMEA Line-walk and error simulation to be strongly linked and aligned with CP guidelines. Develop, maintain, and support procedures, instructions, and training material (PQI, CO, CP Dummy Part/ Red Rabbit Documentation).Definition of measures for closing the target gap for VA and implementation (Cost Engineering & Benchmarking).Planning:Planning of manufacturing sequences and operations, equipment, and resources. Define, acquire, transfer, accept, validate, release, and install production process and equipment according to Bosch standards (Integrations on line, new projects, participate in QGCs, Design for Manufacturing).Planning and further developing of new manufacturing sequences and operations and participate in implementing Engineering and Process Change Requests. Coordination of the implementation and further development of manufacturing technologies in the GB (across sites) and active exchange of lessons learned (Complaints, Equipment, Processes, ...) from other and to other Value Stream and IPN plants.Execute the quality planning (Definition of test strategies, test methods, verification of measure and test process qualification, test data management, Q-control cycle series production). Document the quality planning.Qualifications:Bachelors' degree in mechanical engineering, plastics engineering, manufacturing engineering, industrial engineering, or similar.At least two years of experience developing manufacturing methods, procedures, processes in a production environment. Should have knowledge about safety practices, inspections.In-depth knowledge of materials and mechanics, with application to production systems and tooling. Experience with test bench technology and mechatronics.Experience with continuous improvement, lean principles, and value stream mapping in a manufacturing environment.Should have some experience with 3D CAD systems.#J-18808-Ljbffr