.Job DescriptionThis Job is in charge of one important section inside TEF6. They develop the Standardized Work activities through Time studies, MTM-1 analysis and they balance the job of the operators in the production lines. They are responsible as well to create the operator instructions, capacity tables, Ergonomics analysis, Lay out development, routings creation and controlling.Participate on validations and installations of new production lines or equipment; this according to internal Bosch procedures (Industrial engineering WSR). Actively participate on new projects, in order to comply with Standardized Work requirements that are defined and maintained through Time Studies and MTM-1 analysis, PGL, Ergochecks, etc.Creation and maintenance of the following:Operator Instructions (PQIs)Standardized workLine balancing chartBottleneck matrixTime studies are developed with specific frequency according with CD-04603, Stopwatch or MTM-1 studies. Determination of IE standard times (VT/TEB). Put data in SAP by time management tool CAPP. Support for BP: Routings creation. Define VS allowance time, CT, number of operators (DOs and DNOs). Creation and update of Production routings.Responsible to perform Ergonomics studies according to CD-04605 on any place where the operator is involved (Ergo check + IGEL). Also responsible for closing open points and improving ergonomics conditions (Red and Yellow status). Responsible for ergonomics in MAE application (Initial Ergocheck). Responsible for line layout design, development, and improvement.Defines & acquires the accessories/racks utilized in the production line needed for product handling based on TEF6 procedures. Continuous communication with Value Streams (Daily management) in order to understand lines needs issues, etc.Develop continuous improvement projects (System CIP) on the production lines according to business case defined with the VS team. CIP suggestions follow-up, implementation and documentation. Develop and train associates in Ergonomics, MTM-1 and Standardized work within of Method Room Automation, Digitalization & Simulation support. Implementation of internal and external projects related to TEF6. Productivity calculation and prognosis on a monthly and CF basis.QualificationsEnsure compliance to Quality basic principles.Promote and actively support Bosch Production System, involvement in System CIP Projects, Policy Deployment and Team Work.Responsible for follow-up of labor discipline of his/her personnel if it applies.Is the responsibility of the associate to know and apply the EHS (Environmental Health and Safety) Policies, having, but not limited to the following responsibilities:Fulfill the legal and corporate requirements and regulations applicable.Fulfill the safety procedures applicable to his/her area